Why does my recorder squeak?
A recorder squeaks when air leaks out of a hole that should be closed, or when you blow too hard and the note jumps up an octave. Check that every hole is fully covered first, then blow more gently.
1. Cover each hole with the pad of your finger
A hole that is only partly covered is the most common cause. The hard tip of a finger doesn’t seal well, so lay each finger flat enough that the soft pad covers the hole. A good check is to press the recorder gently and lift it away: each covered hole should leave a small ring on your finger. If one note squeaks and the notes above it don’t, the leak is usually in the last finger you put down. On low C and low D, every finger counts, including both halves of the double holes at the bottom.
2. Use less air and start with “doo”
Too much breath makes a high, beep-like sound an octave above the note you wanted. Yamaha’s recorder guide describes this sound and says the fix is to blow more gently. Start each note with a soft “doo”, as if you were warming your hands, and keep the air slow and steady. Dolmetsch’s online method adds that tonguing too hard can make the recorder squeak, especially on low notes.
3. Seal the thumb hole on low notes
The thumb hole on the back is easy to forget because you can’t see it. If your thumb slides or curls, a gap opens and the recorder jumps to a higher note. Every note from low C to high C needs the thumb hole completely covered. Check by feel: the pad of your thumb should sit flat over the hole, not its tip or the side of the nail.
4. Get the thumb pinch right on high notes
From high E upward, the thumb pinches the back hole and leaves a narrow gap at the top. If the gap is too small, you get the low version of the note. If it is too wide, the note squeaks or breaks. Bend the thumb so the edge of the nail rests in the hole, then blow a little faster than for low notes. Try it on high E, high G and high A first.
5. Clear a wet or blocked windway
If the sound turns fuzzy or breathy, water has collected in the windway, the narrow channel you blow through. Yamaha’s care guide says to cover the window, the opening under the mouthpiece, lightly with a finger and blow firmly to push the water out. Keep your finger off the sharp edge of the window. A cold recorder collects water faster, so warm the head joint in your hands before you play, especially in winter.
6. Check for a loose or cracked joint
Most recorders come apart in two or three pieces. Push the joints together with a gentle twist until they are snug, with the window on the head joint in line with the finger holes. A joint that wobbles or a crack in the plastic lets air escape, and then even well-covered notes squeak. Yamaha’s care guide says to grease cork joints when you put the recorder together. If the recorder still squeaks after every other fix, try another recorder: if that one plays cleanly, yours is probably damaged.
7. Relax your right-hand fingers
Pressing hard does not seal a hole better. Yamaha’s guide says you don’t need to press with excessive force. Tense fingers tend to slide off the holes, and the right ring and little fingers often move together without you noticing. Keep the fingers curved and loose, and ask someone to watch your hand while you play low E and low D.
Questions
Why does my recorder squeak on low notes?
Usually a hole is not quite covered, often the thumb hole or one of the double holes at the bottom. Seal each hole with the soft pad of your finger and use slow, gentle air.
Why does my recorder squeak on high notes?
Usually the thumb pinch is too wide or the air is too strong. Leave only a narrow gap at the top of the thumb hole and blow a little faster than for low notes, without forcing.
Why does my recorder sound fuzzy?
Water in the windway. Cover the window lightly with a finger and blow firmly to clear it, and warm the head joint in your hands before playing.
Notes with their own squeak advice: low C, low D, low E, and the thumb-pinch notes high E, high F, high F♯ and high G. The fingering chart shows every note.
Updated 12 November 2026.